Intake Manifold

Bounty: $4.80

Posted By: HelpIdentify
Listed: March 30, 2020 Ends: June 28, 2020

I'd Like to Know:

what make and model this will fit

Item History: none

Size: carb pipes spacing measure: OD: 2" ID:P 1-3/4" center to center is 3-1/2"

Markings: none


Identify This

Have Something to Identify?

Opinions


its a custom turbo intake plenum probably for an SR20DE or KA24DE used in nissan 240sx cars basically u cut off factory runners and clamp these hoses on them, they also did individual throttle body systems similarly the weld on throttle body flang is from the EBAY sold Billet SR20 70mm Throttle body, you can see its the same flange welded to it as u have bolt holes matching up and an inner slant lip inside the circle where the flange steps down from 70mm to about 60mm or so

References:

https://www.ebay.com/itm/70mm-Throttle-Body-for-Nissan-Silvia-SR20-S13-S14-S1...

By: Nerophine

Submitted on: 03/26/2020 at 04:54AM
Pending

There is not going to be any kind of way to identify this correctly as it’s a custom made turbo intake that’s for a motor cycle. All have to measure the carb spacing on it to figure out exactly what it will fit but most likely a Suzuki or Kawasaki large cc motor cycle. I will attempt to find something but doubt it as looks custom. But it is not for any car definitely a motor cycle. Look at link will see it’s similar but going to be very hard to figure out exactly which bike this is made to fit. Probably was part of a built kit someone sells.

References:

https://www.google.com/amp/s/store.schnitzracing.com/amp/rcc-turbo-billet-alu...

By: Lt1z350

Submitted on: 10/07/2019 at 01:23PM
Rejected

Reason:
thank you for the opinion, I agree but I need little more about fitment, carb pipes spacing measure: OD: 2" ID:P 1-3/4" center to center is 3-1/2"